Laying instructions for Vibro form Table floor tiles:
1. Prepare the base mortar In a cement and sand ratio of 1:4.

2. Set the levels and slopes of the floor as specified by the architect/contractor.

3. Spread thick slurry mixture of cement and water on the leveled base mortar.

4. Wet the backside of the tile with water.

5. Clean the surface of the tile with clear water and sponge, immediately after laying.

6. The laid area should be left undisturbed for at least 24 hours

7. To obtain a clean surface, wash the surface with soap water or mild detergent.

MANUFACTURING PROCESS Visit www.flyashbrick.in